E N G L I S H | 9 - Carl F. Bucherer PATRAVI CHRONODATE Manual Del Usuario

SET THE DATE
Pull the crown into
1
position 2.
Set the current date by
2
rotating the crown counter-
clockwise.
3 Press the crown against
the case and simultane-
ously turn clockwise until
it is firmly secured.
8 | E N G L I S H
MEASURE TIME (CHRONOGRAPH)
The chronograph can be used to measure time
intervals for up to 1 hour exactly to 1/ 8 sec-
ond. The time measured can be read using the
seconds and minutes counters.
Start measuring time
1
using the P1 pusher.
The seconds counter is
in motion.
To stop measuring time,
2
press the P1 pusher again
and read where it stopped.
3 Use the P2 pusher to reset
all the counters to zero.
CLEANING AND MAINTENANCE
CLEANING
To clean the outer surface of the watch, wipe
it gently with a microfiber cloth. Use a fine
toothbrush and a bit of soapy solution to
clean the back of the watch and the metal
band. Dry using a lint-free towel. Minimize
contact between the leather straps and the
water.
MAINTENANCE
As a mechanical instrument, a watch
requires maintenance by an authorized
service center about once every four years.
WATER RESISTANCE
A watch tested to 5 atm (50 m) may be worn
while bathing, showering or swimming (such
as in a pool). Water resistance is guaranteed
only if the crown is screwed in and should be
checked once per year.
THE BINDING NATURE OF METER DATA
Do not swim/dive 30 m | 3 atm
Bath, shower, swim 50 m | 5 atm
100 m | 10 atm
Swim, snorkel
Swim, snorkel, dive 200 m | 20 atm
Deep-sea diving 300 m | 30 atm

E N G L I S H | 9