Getting Started; Setting Up; Connecting Up The Large Base; Connecting The Handset And Charger - Motorola D700 Serie Manual De Instrucciones

D701_IFU_EN_for_EU.book Page 5 Friday, August 24, 2007 5:19 PM

1. Getting started

WARNING
Do not place your D701 in the bathroom or other humid areas.
Location
You need to place your D701 base within 2 metres of the mains power socket and telephone
socket so that the cables will reach.
Make sure it is at least 1 metre away from other electrical appliances to avoid interference. Your
D701 works by sending radio signals between the handset and base. The strength of the signal
depends on where you site the base. Putting it as high as possible ensures the best signal.
HANDSET RANGE
The D701 has a range of 300 metres outdoors when there is a clear line of sight between the base
and handset. Any obstruction between the base and handset will reduce the range significantly.
With the base indoors and handset either indoors or outdoors, the range will normally be up to 50
metres. Thick stone walls can severely affect the range.
SIGNAL STRENGTH
The icon on your handset indicates when you are in range. When out of range of the base,
the screen shows SEARCHING the flashes and the handset gives an out-of-range warning tone
every minute. This tone is repeated until you move back into range.
If you are on a call, the line will hang up. Move back within in range. The handset will automatically
re-connect to the base.

Setting up

IMPORTANT
The base station must be plugged into the mains power at all times. Do not connect the telephone
line cord into the wall socket until the handset is fully charged. Only use the power and telephone
cables supplied with the product.
WHICH POWER ADAPTOR?
The power adaptor with a clear connector is for the base unit and the power adaptor with a red
colour connector is for the charger unit.
Getting started

Connecting up the large base

Plug the large mains power cable into the socket marked
plug the other end into the mains power wall socket and switch the power on.

Connecting the handset and charger

If you have purchased a multiple pack, this process will need to be carried out for all handsets and
chargers:
1. Plug the small mains power cable into the socket marked
charger.
2. Insert the 2 x AAA NiMH batteries supplied into the handset. Then slide the compartment
cover into place.
3. Place the handset on the charger to charge for at least 24 hours. When the handset is fully
charged the icon will indicate that it is fully charged.
4. After 24 hours, plug the telephone line cord from the large base into the telephone wall
socket.
on the underside of the base and
on the underside of the
5