Assembly - Husqvarna TS 148XK Manual Del Usuario

• Let the product become cool before you do
maintenance near the engine.
• The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
• Always put the cutting deck in servicing position
to clean it. Do not park the product near the edge
of a ditch or slope to get access to the cutting
deck.
CAUTION: Read the caution instructions
that follow before you use the product.
Introduction
WARNING: Read and understand the
safety chapter before you assemble the
product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Remove the end panels.
3. Remove the side panels and put them on a flat
surface.
4. Remove all package materials.
5. Remove the product from the carton and make
sure no loose parts are left in the carton.
Assembly tools
• 1/2" wrench
• 7/16" wrenches (2 pieces)
• Tire pressure gauge
• Knife
• Pliers
• Socket wrench set (optional)
Loose parts that need assembly
The product is not fully assembled. The parts that
follow are loose when the product is purchased.
Key, 2 pcs
Slope sheet, 1 pcs
Hex bolt, 2 pcs
10
• Do not turn over the engine if the spark plug or
ignition cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good
condition.
• Do not change the adjustment of governors. If
the engine speed is too high, the product
components can become damaged.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.

Assembly

Nuts, 2 pcs
Nozzle adapter, 1 pcs
Oil drain tube, 1 pcs
To install the lower cover
1. Install the lower cover (B).
2. Carefully push the lower cover (B) to attach it to
the cover tabs (C) in the slots that taper (D).
B
A
3. Install the fastener (A) to the lower cover (B).
4. Lower the engine cover.
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2. Loosen the seat adjustment knob (B).
C
CAUTION: Be careful when you
attach the lower cover, there is a risk
of damage to the lower cover tabs
(C).
1717 - 001 - 10.09.2021
D