Operation - Husqvarna TS 148XK Manual Del Usuario

• Examine the cutting deck and the drive belts.
Make sure that the drive belts are installed
correctly around the pulleys and inner part of all
belt keepers.
• Examine the electrical wires. Make sure that all
wires and connections are safe.
• Make sure that the freewheel control is in the
"Transmission engaged" position. Refer to
Transportation on page 34 .
• Make sure that the engine oil is at the correct
level.
• Make sure that the tank is filled with the correct
type of fuel.
Introduction
WARNING: Read and understand the
safety chapter before you use the
product.
To fill fuel
WARNING: Gasoline is very flammable.
Be careful and refuel outdoors. Refer to
Fuel safety on page 8 .
CAUTION: Always use correct fuel type.
Incorrect fuel type causes damage to the
product.
• Use gasoline of the correct type. Refer to
Technical data on page 35 . For more
information about the fuel, refer to the engine
manual supplied by the engine manufacturer.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.
To start the product
To do before you start the product
WARNING: Before you operate the
product, carefully read and understand
the safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
a check of the engine oil level on page 27 .
2. Fill the fuel tank with fuel. Refer to
page 12 .
3. Disengage the freewheel mode. Refer to
the product in freewheel mode on page 16 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
and disengage the parking brake on page 14 .
12
•
•
•
•

Operation

6. Make sure that the cutting deck is disengaged.
To start a warm engine
1. Sit on the seat.
2. Make sure that the cutting deck is disengaged.
3. Put the cutting deck in transport position. Refer
4. Move the throttle control to the fast position.
5. Push down on the brake pedal fully and hold it
6. Put the ignition key into the ignition.
7. Turn the ignition key to the "START" position and
To do
8. If the temperature is low, let the engine become
To fill fuel on
To put
To engage
Make sure that you know the location and
function of all controls.
Make sure that the brake system is in safe to
operate condition.
Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 7 and
To do a check of the reverse operation system
(ROS) on page 7 .
Remove the air from the transmission before first
To remove the air from the
use. Refer to
transmission on page 28 .
To engage and disengage the cutting
Refer to
deck on page 15 .
To engage and disengage the cutting
Refer to
deck on page 15 .
To set the cutting deck in transport position or
to
mow position on page 13 .
down.
release the ignition key when the engine starts.
CAUTION: Do not operate the starter
continuously for more than 15
seconds for each minute.
warm before you start to cut grass.
To do a check of the
1717 - 001 - 10.09.2021