HURAKAN HKN-HCP5 Guia De Inicio Rapido página 6

EN
1. Introduction
The grill has a stylish, thoughtful design, easy to use, quickly heated, and can be used in hotels,
shopping centers, supermarkets, places with a large flow of visitors.
2. Technical specifications
Model
HKN-HCP5
HKN-HCP6
3. Installation
3.1 Installation conditions
The device must be installed in a well-ventilated place. There should be enough space for the
installation of ventilated hoods or an exhaust fan.
3.2 Equipment location
- the equipment is suitable for built-in installation;
- the machine can be installed against the wall, the distance to the wall must be at least 100
mm;
- it is necessary to ensure a smooth level surface for installation;
- it is necessary to provide the appropriate exhaust.
Attention!
※ The equipment installation and maintenance must be carried out by qualified installation
specialists or installation specialists authorized by the supplier.
4. Operation
Turn the thermostat knob to set the temperature, when the thermostat turns off, proceed to the
next stage of operation.
5. Safety requirements and maintenance
5.1 Do not perform maintenance when the power supply is on.
5.2 Do not wash the grill with water, it is strictly forbidden to clean the equipment with
immersion in water.
5.3 Do not wash any metal parts with cleaning agents
5.4 After using, it is necessary to clean the work surfaces in a timely manner to ensure the
hygiene of the grill.
6. Maintenance
6.1 Do not use cleaning agents that cause wear or corrosion of the machine surface.
6.2 The maintenance personnel must be trained and it is forbidden to perform maintenance
when the power supply is on.
6.3 To ensure safety and long service life of the equipment, it is necessary to regularly
remove product residues and dirt. (Recommendation: do it at least once a day).
6.4 If it is necessary, clean the surfaces in a well-ventilated area.
6.5 Clean the surface daily with warm soapy water, then rinse thoroughly (do not rinse the
equipment with a compressed water).
6.6 Do not use cleaning agents; do not use tools such as a rough brush or a bottle brush to
clean surfaces. It is forbidden to use the means containing chlorine (whiteness,
hydrochloric acid, etc.) to clean surfaces even if it is dissolved.
6.7 It is forbidden to use corrosive substances (such as: potassium chloride) The surface
under the equipment must be cleaned.
6.8 Do not make any changes to the machine design.
6
Power, kW
1.55
1.55
Voltage, V
220 360*330*245
220 360*330*245
Dimensions, Mass, kg
(mm)
7.5
8.5