GENERAL DESCRIPTION
A Protective mesh - front
B Airscrew
C Protective mesh - rear
D Body
E Arm
F Base
G Oscillation switch
H Switch and gears: I, II and III
G
H
TECHNICAL DATA
power: 40W
supply voltage: 230V ~ 50Hz
USE AND INSTALLATION OF THE DEVICE
Before first use, unpack the device and assemble its components.
- Install the rear protective mesh (C). The mesh holes shall match the holes in the
housing, Fig. 1. Fasten with the enclosed screws , Fig .2.
- Slide the blade (B) onto the pin, Fig. 4 so that the screw hole is directly above
WGC40M / WGC-40
DESK FAN
A
B
E
F
INSTRUCTION MANUAL
C
D
9
EN