Publicidad
Step. 2
Step. 1
AA1.5V
User Manual – EN
OperatiOn: Take the clock out of the box and put 1 x 1.5V (AA) battery (not included) into the movement as shown. Set time by turning the time knob
on the back of the unit (movement) following indicated turning direction.
Warning: Never turn the hands (minute and second hands) anti-clockwise; this will damage the movement. Remove consumed batteries before storing
the clock otherwise the movement will be damaged.
Care and Handling (fOr StainleSS Steel and aluminum material ClOCkS): Make sure that if your clock is stainless steel or
aluminum material, you do not touch the case surface with bare hands, spots and finger prints will appear on the clock surface. Please unpack the clock
with covered hands. To remove spots or finger prints, you can buy special stainless steel polish in shops.
SpeCial funCtiOn (glOW in tHe dark): If your clock comes with a "glow in the dark" function on the dial (clock face), here below is the data for
your reference • Glow in the dark effect can generally last for a maximum of 4 hours • The length of glow relies on many factors ie
1. how bright the light source where the clock is put around with
2. even there is light in the room, location of the clock can affect light absorbance which in turn affects the brightness and length of glow
3. within the length of glow, brightness is expected to fade off gradually
• After approximately 1.5 - 2 years, the luminosity of the dial will decrease in strength.
4
Publicidad
