Electrical Installation - Johnson Pump SPX Flow Bilge Pump Manual De Instrucciones

> English
Bilge pump control 12 or 24 V
Part No.
12 V – 34-1224
24 V – 34-1225
The bilge pump control combined
with an automatic switch is an
excellent installation for your boat.
The panel has a 3-position switch
for Off, manual On, and automatic
operation – the automatic feature
operates in combination with
an automatic switch.
Integrated fuse holder and
operating light. Fuses included. The
switch is in matt black finish.
Size: 73 x 60 mm.

ELECTRICAL INSTALLATION

See fig. page 9
SPX FLOW Johnson Pump
submersible bilge pump/
Automatic Switch/ Bilge pump
control
Always install the switch and bilge
pump control or other switches
or fuses between the positive (+)
terminal of the battery and the
positiv (+) connection of the pump
4
(brown wire).
The negative (-) connection (black
wire) of the pump to be connected
directly to the negative (-) terminal
of the battery. Fuse size applies to
pump specification.
Electrical connections
All electrical connections must be
placed above the highest water
level. The wire connections should
be sealed with a marine sealant to
prevent wire corrosion. Insulation
or cable sheathings have to be
removed in such a way that they
end well above the highest bilge
water level.
Waste handling/
material recycling
At the products end of life,
please dispose of the product
according to applicable law. Where
applicable, please disassemble
the product and recycle the parts
material.
Original instructions