Installation Types - Maxx Ice MIM250 Manual De Servicio

Ice Maker Installation

INSTALLATION TYPES

This ice cube machine has been designed to be enclosed (as under a cabinet) It can also be free-
standing (using the supplied stability brackets) or built-in (sealed to the floor). In every case, there
must be adequate air space around the unit for ventilation purposes
Enclosed Installation:
An enclosed installation will allow you to install the ice cube machine under a counter or in a kitchen
cabinet provided the required clearance space around the ice maker is respected You must follow
the stated instructions for
a Electrical requirements
b Water supply
Free-standing Installation:
The ice cube machine can be installed to be free-standing in any place you desire provided you
have access to a water supply This installation has the same requirements as an enclosed installation,
plus you must also follow the stated instructions for Installing the Stability Brackets
Built-in Installation:
If this method of installation is chosen, it will still be necessary to allow adequate ventilation space
around the unit The following additional items must be observed
1 Place the ice cube machine in front of the installation location Raise the machine and place it on
the floor or on a platform depending on your installation requirements.
2 The water supply line must be plumbed before connecting to the ice maker
3 Turn on the main water supply and tap Check for water supply connection leaks Tighten every
connection (including connections at the water inlet)
4 If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker
5 Push the ice maker into position
6. Seal all around the cabinet to the floor with an approved caulking compound.
LIGHT BULB REPLACEMENT
1 Upper light bulb replacement: Loosen the screws in the bottom of top shroud, swing the top shroud
up until it is held by the top of the cabinet, now the light bulb can be replaced;
2 LED light bulb replacement: Take the cover off, then the LED bulb can be replaced
SERVICE AND INSTALLATION MANUAL
www.maxxfoodservice.com
10