Conceptronic Home Media Store CH3HNAS Manual De Usuario Ampliado página 97

RAID function
Note: If you have 2 hard disks of different sizes and you select "RAID 0" or "RAID 1" as hard disk
configuration, a part of the largest disk cannot be used in the raid configuration. This part will be
configured as an extra storage space without any raid function.
Delete disk partition
Repair hard disk
Rebuild RAID
S.M.A.R.T.
Power management
Turn off harddisks after : Specify the time of inactivity before the hard disk(s) go in standby mode.
Apply
: Select a RAID configuration for the Home Media Store.
JBOD : Both hard disks will be combined as 1 big harddisk.
RAID 0 : Both hard disks will be combined as 1 big harddisk, following the
„Raid Striping‟ medhod. This means that when you store a file to
the Home Media Store, a part of the file will be stored on each
hard disk to improve the performance.
RAID 1 : 1 hard disk will be made available, and the second hard disk will
be made a mirror of the first harddisk. This means that when you
store a file on the Home Media Store, the file will be stored on
each hard disk to improve safety.
: Delete the partitions on your hard disk(s). This will erase all your data!
: Repair the hard disk(s) if there are errors.
: Rebuild the RAID configuration in case one of your hard disk(s) has failed and is
replaced by a new one.
: Enable or Disable to read S.M.A.R.T. information from your hard disk(s).
With S.M.A.R.T. enabled, the hard disk(s) can send their disk health status and
monitoring info to the Home Media Store, so the hard disk(s) can be monitored.
: Enable or Disable power management. When enabled, the Home Media Store
will put the hard disk(s) to standby when they are not used.
: Apply the configured settings.
ENGLISH
97