ASROCK Q2900M Manual De Instrucciones página 16

Serial ATA2 Connectors
(SATA2_1:
see p.1, No. 6)
(SATA2_2:
see p.1, No. 8)
USB 2.0 Headers
(9-pin USB4_5)
(see p.1, No. 11)
(4-pin USB6)
(see p.1, No. 10)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 15)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
14
These two SATA2
SATA2_1
connectors support SATA
data cables for internal
SATA2_2
storage devices with up to
3.0 Gb/s data transfer rate.
Besides three USB 2.0
USB_PWR
ports on the I/O panel,
P-
P+
GND
there are two headers on
DUMMY
this motherboard.
1
GND
P+
P-
USB_PWR
1
GND
P+
P-
USB_PWR
This header is for
GND
PRESENCE#
MIC_RET connecting audio devices
OUT_RET
to the front audio panel.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L