Tunturi Upright Bike Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Step 4: Console, Seat, Pedals And Main
Housing Covers Assembly
1. Insert the Computer Cable (29) and two Hand pulse
cables (26) into the connectors in the back of the
Console (34). Install the Console (34) onto the Up-
right tube with four M5x12mm Phillips Head Screws
(58).
2. Install the Front Foot Cover (40) and the Rear Foot
Cover (41) onto the Main Frame (1) with four
M5x12mm Phillips Head Screws (58).
3. 3. Install the Pedals (45 L, 46R) onto the Crank
arms (16L, 16R). Remember that the left pedal has a
reverse thread and will be screwed into the crank in
the opposite rotation from normal threads. There is an
"L" stamped into the end of the threaded post of the
4.
English
6
left pedal and an "R" in the right. Make sure to
tighten the pedals as much as you possibly can.
It may be necessary to re-tighten the pedals if you
feel a thumping during pedaling the bike. A noise
or feeling such as a thumping or clicking is usually
caused by the pedals being too loose.
4. 4. Install the Seat slide tube (7) onto the track
on top of the seat tube with the seat post facing
forward. Install the seat (19) onto the seat post.
5. 5. Install the Bottle Holder (116) onto the Upright
tube with two M5x12mm Phillips Head Screws
(58).

Publicidad

Tabla de contenido
loading

Tabla de contenido