Troubleshooting - Steinbach Poolrunner Battery Basic Manual Original

Ocultar thumbs Ver también para Poolrunner Battery Basic:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 94

Troubleshooting

Fault description
The device cannot be switched
on.
The charge control indicator is
not lit.
The device beeps.
The device continues beeping
after it has been placed in the
water.
The device cannot reach all
spots.
The device does not turn
around at the pool wall.
The device floats up or turns in
a circle on the pool floor.
42
Cause
The rechargeable battery is
drained.
The rechargeable battery is
defective.
It takes about 15 seconds after
the ON/OFF switch is pressed
before the device starts.
The charger is defective.
The device is out of the water.
The device is defective.
The wheel setting does not fit
the pool size.
The pool has a special shape.
The water circulation of the
pool is switched on.
The sail, the water discharge
nozzle or the cleaning strip is
stuck.
Too much air in the housing.
The pH value and the chlorine
quantity are not properly set.
The salt content is too high
and the device has more
buoyancy.
Remedy
Charge the rechargeable
battery.
Contact customer service.
Wait approximately 15 seconds
until the device starts.
Contact customer service.
Place the device in the water.
Contact customer service.
Adjust the wheels to fit the
pool size.
Adjust the wheels. Select the
setting for small pools.
Switch off the filter system of
the pool.
Remove the obstruction,
remove the cleaning strips or
contact customer service.
Let all air escape.
Adjust the pH value to the
correct value. See section
"Technical data".
Set the correct salt content.
See section "Technical data".

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

061205

Tabla de contenido