turbionaire SENSO 20 Manual De Instrucciones página 13

Long Press humidity button for 3 seconds to display the current ambient temperature.
FAN SPEED (SPEED)
High wind - low wind cycle, press button once to switch and then the corresponding
LED indicator lights up. In continuously drying mode, sleep mode and defrosting period, the
wind speed cannot be changed.
CHILD-LOCK (LOCK)
Long press 3 seconds to turn on/off the child lock function.
WATER TANK FULL ALARM
•
Water Tank Indicator
When the tank is full, it sets the alarm for 5 seconds. The full tank LED indicator turns red
and the unit buzzes for 5 times. This LED can be found on the control panel just above the
POWER LED.
•
Clear the alarm
When the buzz is on, press any button to stop it. The compressor and the fan shut down and
all the functions freeze until the water tank is emptied and back in right position.
A. Drainage
There are two ways of removal collected water produced by the unit.
A. Manual draining: the water tank is removed manually.
B. Continuous draining: attach a drain hose to the unit so that the condensed water is
drained by using gravity.
B. Emptying the water tank
The unit will shut down once the water tank is full. It will run again once you have emptied
the water tank and reinstalled it properly. When the tank is full, the unit will make a buzzing
sound, and the "Water Full" LED will turn on.
• Press the POWER button to turn off the unit.
•
Pull on the water tank and slide out of the body of the dehumidifier.
•
Empty the water into an area with a drain or outside.
•
Clean the inside of the tank, if necessary, as well as the outside.
•
Replace the empty tank back into the unit.
•
Press the POWER button to restart the unit.
•
If the "Water Full" LED is still on, check if the water tank float is
correctly placed and free from any blocking.
13