Adjusting Thread Depth On Nos. 924, 926, And 928 Die Heads - RIDGID 1233 Manual Del Operador

1233 Pipe and Bolt Threading Machine
6. At end of thread, receding mechanism will automati-
cally open the die head.
NOTE! Certain machines do not include foot switch.
7. Turn machine OFF. Turn carriage handwheel to back
carriage away from chuck.
8. Reset cocking lever on die head, and place die head
in UP position.
Figure 8 – Cocking the Receding Die Head
Figure 9 – Starting Thread with Receding Die Head
Figure 10
Adjusting Thread Depth on Nos. 924,
926, and 928 Die Heads
1. To correct deep threads; loosen depth adjustment
nut and move slightly toward the (+) marking on die
head size bar. Tighten adjustment nut. (Figure 10)
2. To correct shallow threads; loosen depth adjustment
nut and move slightly toward the (-) marking on die
head size bar. Tighten adjustment nut. (Figure 10)
Ridge Tool Company
+
+
-
-
9