Cleaning And Care - Ottobock 9E420-L Instrucciones De Uso

10.7 EVO Digital control with 1 electrode
INFORMATION
For this control mode, an electrode must be connected to input1.
This control mode is used for easier control of the prosthetic component for toddlers or children
which cannot differentiate the different muscle signals.
Opening and closing of the prosthetic component is controlled by only one electrode. When suf-
ficient muscle signal is generated (ON threshold exceeded), the electric hand opens at a constant
speed, and closes again at a constant speed when the muscle signal disappears.
The gripping strength can be adjusted via the 560X3=* MyolinoSoft software.
Digitally; signal on the electrode opens the prosthetic component at constant speed.
Opening:
Digitally; the prosthetic component closes at constant speed without a signal on
Closing:
the electrode.
Program
EVO digital Sustained electrode signal
Speed
constant
11 Opening the Electric Hand in Emergencies (Fig. 21)
The 7in1 Controller is equipped with an „EMERGENCY OPEN Switch". This safety function makes
it possible to quickly open the electric hand without myo signals.
Pressing the MyoEnergy Integral 757B25=1 or 757B35=* charging receptacle button (Fig. 21
arrow) opens the electric hand and the system turns off. This requires pressing the button for ap-
prox. 3 seconds (Fig. 21, arrow).

12 Cleaning and Care

Clean the product with a damp, soft cloth and mild soap (e.g. Ottobock 453H10=1 Derma Clean) when
needed. Make sure the product is not damaged and that no liquid can penetrate into system components.
Then, dry the prosthesis component with a soft cloth.
28 | Ottobock
OPEN
No electrode signal
Grip force: maximum
Speed
constant
CLOSE
For patients with 1
weak electrode signal.
Indications
9E420=L, 9E420=R