Customizing The Wash Cycles - Fisher & Paykel AquaSmart Instructivo De Instalación Y Guía De Usuario

Soak
The Soak option adds a 2 hour soak into the middle of the wash phase of the
cycle. During the soak, the washer will agitate for a few seconds every minute.
At the completion of the soak period the AquaSmart™ will then complete the
rest of the wash cycle. To select Soak, press the SOAK button once to select
Soak ON.
Note: Once the Soak is under way you can exit out at any time by pressing
the SOAK button. This does not apply to BULKY cycle. For BULKY cycle to exit
SOAK press ADVANCE.
Wash Advance
There may be times when you wish to use the rinse and spin or spin only
portions of the wash cycle. The Advance option allows you to fast forward
your cycle to the desired location. Press the ADVANCE button repeatedly to
advance the cycle to the desired position, then press START.
Note: If you wish to change any of the wash options while your AquaSmart™ is running please
press START/PAUSE then change the required option.

Customizing the wash cycles

To customize a cycle
You can program your AquaSmart™ to remember the wash options you prefer for each wash
cycle. For instance, you may want to set the Regular cycle to a cold wash.
Press POWER.
1
Press the wash cycle button.
2
Select your wash options (eg. cold wash).
3
Press and hold down the wash cycle button for 2 seconds, until you hear a beep. This will store
4
your customized cycle for future washes.
To change your customized wash cycle simply repeat the steps above. Note: You will be unable
to customize a wash cycle to start at the rinse or spin stage.
Fig.18 Customizing the wash cycle
Changing the wash cycle options
27
EN