Machine Installation - Polieri TECH 140 Manual De Instalación, Uso Y Mantenimiento

Hormigonera
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

monoxide and other harmful gases cause harm to exposed persons. is necessary in these cases to convey the
exhaust out at a safe distance from the place where there is the presence of staff.
unfamiliar with the controls of the machine.
body.
moving parts.
to extinguish fires.
The machine may be moved only on a special road transport system in compliance with the rules of the road. the
towing by motor vehicle is allowed only and exclusively in the yard. it is strictly prohibited to tow on the road.
handling in the pipeline can also be manually lifting the machine on the side of the steering wheel of rotation of the
cup and using the wheels or via a lifting mean.
The cement mixer has been designed and manufactured in accordance with the rules EN6020, protected against
splashing water (IP55) and has protection against overload of undervoltage. in the pipeline is necessary to connect
the machine structure to a ground system using a cable of minimum 16mmq.
The switch has a minimum voltage coil, in case of interruption of the supply voltage, the motor stops. Only by
pressing the button 'on' , you can re-enable the operation of the engine. The not prompt restart of the machine is
impossible without the consent of the operator. All gears, belts and moving parts are protected by suitable covers.
The engine is protected by thermal overloads – in case of overheating it stops. To re-enable the engine, it must cool
down before.
The customer receives the cement mixer ready for the use. To start the machine is important to ensure the presence
of some technical devices and operations necessary for the proper use:
with devices indicated.
section that does not produce excessive voltage drop which must never fall below 2.8% of the nominal one. all
connections and electrical systems and ground should be done by a qualified technician in accordance with the
provisions of the 46/90. in the functioning of the internal combustion engine or diesel should be noted that the
power decreases by 0.8% for every 100 meters above the sea level and of the 1.7% every 4 ° of temperature above
20 °C.
power plug.
up at a reduced rate. avoid putting the machine on a full load. The operation of the engine with a low amount of
oil can cause serious damage.
EN
TRANSPORT SYSTEM OF THE MACHINE
SECURITY SYSTEM

MACHINE INSTALLATION

10

Publicidad

Tabla de contenido
loading

Tabla de contenido