GlobalGym G152X Instrucciones De Montaje Y Utilización página 39

as shown in Fig.12.
Now take the handle (26), remove the
bolt and the washer Fig.12 and screw it
on to the arms (20) right and (21) left.
FITTING THE SEAT STRUCTURE.-
11.- Take the knob from the seat
support (136). Position it on one of the
two seat height setting holes Fig.13
and secure using the knob.
Fit the seat locking pin (71).
FITTING THE SEAT HANDGRIP.-
12.- Insert the handgrip (32) through
the lower part of the seat support,
Fig.13. Attach using bolts (108),
washers (119) and nuts (125).
FITTING THE SEAT.-
13.-Take the seat (88) and position it
on the seat support Fig.13.
Fit the bolts (99) with their washers
(118) and tighten securely.
FITTING THE BOTTOM FOAM
COVERS.-
14.-First take the foam covers (131)
and fit them onto the top rounded
tubes for the leg support Fig.14.
Now do the same for the bottom leg
support foam covers (94).
FITTING THE GLUTEAL
ACCESSORY.-
15.- Position the rear support (7), next
fit the cross support (8) and screw it
on to the outer seat frame (3 and 4),
Fig.15. Fit bolts (109) along with
washers (120) and nuts (125).
Now take the gluteal support (9),
Fig.16, and attach it to the supports
(7) and (8) using bolts (110), washers
(119) and nuts (125) Fig.16.
NOTE: Once
assembly has been completed, all of
this stage of
the bolts fitted previously should be
retightened securely.
FITTING THE SEAT HANDGRIP.-
16.– Position the handgrips (16) and
(17) on the gluteal support (9), Fig.17.
Attach using bolts (110), washers
(119) and nuts (125).
FITTING THE GLUTEAL SEAT.-
17.-Take the seat (87) and position it
on the seat support, Fig.17.
Fit the bolts (99) with their washers
(118) and tighten securely.
FITTING THE PUSH BARS.-
18.- Position the push bar (11) on the
"U" bracket for the gluteal support (9),
Fig.18, align the holes and insert
screws (116), fit washers (121) and
tighten using nuts (126). Now fit the
screw caps (73).
Go through the same procedure for
push bar (12), Fig.18.
FITTING THE GLUTEAL PUSH BAR.-
19.- Position the gluteal push bar
support (14) as shown in Fig.19.
Align the holes on the push bars and
insert bolts (116) along with the
washers (121) and nuts (126), tighten
securely. Fit the screw caps (73).
Take push bar (15) and insert it
through the gluteal support in the
direction of the arrow, fit bolts (105),
washers (119), and nuts (125) and
tighten securely. Adjust to suit and
tighten it by turning the control knob
(119) clockwise.
FITTING THE GLUTEAL CABLE.-
20.- Pass one end of cable (66),
Fig.19, coming out of pulley D1,
through pulleys E1 and F1, take the
the
carabiner (60) and attach it to push
39