GAP Supply VQ-LED-600WW Manual De Instalación Del Uso Y Mantenimiento página 6

Equipo de cinta de luz led de 16 pies con atenuador de inalámbrico quattro
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

raz-wr96 hookup guide
Pre-Installation
Tools Required
Wire
Strippers
-
Flat Blade
Screwdriver
+
Philips
Screwdriver
1
1. Remove cover with Phillips screwdriver.
4
4. Attach the female barrel connector to the male
plug cable. Push together to make the connection.
7
7. Verify that all connections polarity are correct
(Red to + and Black to -)
2
2. Loosen the 4 flat head terminal screws using the
flat blade screwdriver. Connect the male and femail
plug cables, or connection wire. Titen 4 screws.
(+Red wire) (- Black wire)
5
5. Cut the connection wire to desired length and route to
LED strip location. Strip wire back 3/16" and insert into the
Female barrel connector terminals. (Red to + and Black to -)
Tighten screws down with Philips screwdriver
8
8. Connect the male end of the power supply to the
Female plug cable.
3
3. Attach cover with Phillips screwdriver.
Do not over tighten.
6
Option 1
Factory LED Strip end
Option 2
Cut Strip and use
8MM-EZ connector
6. Route wire from receiver barrel plug to LED strip. Connect
to strip using Option 1 or Option 2. (See the 8MM-EZ guide
for detailed cutting and connecting instructions)
9
9. Plug in the power supply and proceed to the
pairing instructions

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

008690830003

Tabla de contenido