Customer Service - Hellrazr YAMA-U-CG-1 Manual Del Usuario

Using your YAMA™ Charcoal Grill
as an offset reverse flow smoker.
• Open exhaust traps to the wide-open position.
• Using your YAMA™ Grill as a reverse flow smoke
requires the smoke baffle accessory (Hellrazr™
Part Number # YAMA-A-SB-5) which is available
through your local dealer.
• Open air flow damper on the fire box to
the wide-open position.
• After the fire has started, using the grill tool
push the fuel towards the side door located on
the right side of the unit. Take the smoke baffle
and insert into the unit letting it rest on the grill
support brackets paying close attention the rails
are free of ash and debris.
• Special attention is required to always use
flame retardent protective gloves and clothing
and always attach long hair when adding or
removing the smoke baffle plate.
• DO NOT USE petrol-based accelerants or
cubed fire starters to start fire.
• Using kindling wood or charcoal build your
fire inside the firebox.
• Close the firebox air intake damper and the
exhaust trap on the right side of the unit.
• If at anytime during your cook you need to
add fuel, simply lift the latches on the side door,
Questions, comments or technical support.
Please contact us at 1 855-958-1889 or by emailing us at info@hellrazroutdoorcooking.com
CUSTOMER SERVICE: 1 855-958-1889 • EMAIL: info@hellrazroutdoorcooking.com
Hellrazr Outdoor Cooking Products Inc.
2050 Power St., Drummondville
Quebec, Canada, J2C 7V6
remove the door, add fuel and replace the door
and close the latches when done. Always wear
protective gloves when touching the unit.
Cleaning and maintenance.
• DO NOT USE cleaning agents or chemicals to
clean the inside of the unit.
• DO NOT USE metal scrapers, steel wool or wire
brushes to clean the unit. Using metal tools to
scrape the unit can damage the steel's natural
protective scale, scratch the paint and expose
the raw steel to rust and oxidation.
• Using hot water and dish soap rinse the unit
and remove any large deposits by hand.
• Using a sharp-edged wood scraper remove any
grease, soot and ashe.
• Using a coarse threaded towel or rag wipe
down the inside of the unit until it is dry.
• In the event your unit requires paint touch ups,
use 1990 Stove Bright Paint Satin Black. Do not
paint inside the unit. Prepare the surface requi-
ring touch-ups by cleaning and removing and
pain chips, grease or dirt. Using a Scotch-Brite®
Heavy Duty Scrub Sponge rigorously scrub the
area until clean. Using rubbing alcohol wipe the
surface that requires paint. Apply paint and
allow to dry according to paint manufacturers
specifications.