Hellrazr NOMADA-U-CG-3 Manual Del Usuario página 6

Lighting your NOMADA™ Charcoal Grill.
• Your Hellrazr™ NOMADA™ can be used with
wood logs or charcoal.
• Using accelerants or other synthetic products
will contaminate the unit and dramatically affect
the taste of your food. Do not use any type of
accelerant during lighting, liquid, solid
or otherwise.
• When using a chimney style charcoal lighter
place the chimney lighter in the vertical position
over top of the grill.
• Once the charcoal in chimney lighter has
become sufficiently ignited dump the hot coals
into the unit.
• If using spit wood to ignite your fire, build a
small fire ensuring that the fire is no higher than
the grill support brackets.
Seasoning your new NOMADA™
Charcoal Grill.
• Wipe grills down using vegetable oil, lard
or olive oil. (do not apply to any other surfaces
other than the grill themselves).
• Using your favorite hardwood or charcoal light
a fire inside the firebox.
• Season the unit until the fire has extinguished
itself, depending on the type of wood and the
size of fire used this process may take up to
4 hours.
Questions, comments or technical support.
Please contact us at 1 855-958-1889 or by emailing us at info@hellrazroutdoorcooking.com
Hellrazr Outdoor Cooking Products Inc.
2050 Power St., Drummondville
Quebec, Canada, J2C 7V6
www.hellrazroutdoorcooking.com
Cleaning and maintenance.
• DO NOT USE cleaning agents or chemicals to
clean the inside of the unit.
• DO NOT USE metal scrapers, steel wool or wire
brushes to clean the unit. Using metal tools to
scrape the unit can damage the steel's natural
protective scale, scratch the paint and expose
the raw steel to rust and oxidation.
• Using hot water and dish soap rinse the unit
and remove any large deposits by hand.
• Using a sharp-edged wood scraper remove any
grease, soot and ashe.
• Using a coarse threaded towel or rag wipe
down the inside of the unit until it is dry.
• In the event your unit requires paint touch ups,
use 1990 Stove Bright Paint Satin Black. Do not
paint inside the unit. Prepare the surface requi-
ring touch-ups by cleaning and removing and
pain chips, grease or dirt. Using a Scotch-Brite®
Heavy Duty Scrub Sponge rigorously scrub the
area until clean. Using rubbing alcohol wipe the
surface that requires paint. Apply paint and
allow to dry according to paint manufacturers
specifications.