Operation - Wattio THERMIC Manual

All manuals and user guides at all-guides.com

Operation

Consumption
Once the Thermic is installed and registered, the current temperature is registered in the
system and historic temperature is so every 15 minutes together with the time the heater is
ON and the target temperature. The temperature average values will be registered to build the
historical statistics, available via Wattio apps.
OPERATION MODES
The target temperature can be established setting different operation modes.
The thermostat has four operating modes, OFF, AUTO, MANUAL and an additional mode called
AUTO-MANUAL that activates automatically.
The selection or switching between them can be done via web and mobile applications
remotely or manually directly from the Thermic or the GATE.
The different operating modes are explained in detail:
OFF
The heater remains off. However, the room temperature is visible and the average values of
the temperature will be registered every 15 minutes to be accessible through the different
local and remote management platforms.
MANUAL
This operating mode works when the user manually sets the target temperature, either with
the wheel or by the applications. This means that the Thermic will regulate the heater so that
the temperature will be slightly higher or equal to the target one. As in the OFF mode, the user
will have visible the current temperature and the average values will be registered as well
every 15 minutes.
AUTO
This operation mode works when the user programs a schedule. The user will set up a calendar
with the wanted temperature values and the Thermic will perform them automatically. This
performance will be explained in detail further forward.
AUTO-MANUAL
The AUTO-MANUAL mode activates automatically when the target temperature is changed
(auctioning the temperature wheel or from the apps) when the Thermic is in AUTO mode. The
AUTO-MANUAL MODE allows changing temporarily the target temperature of the Thermic
established by the calendar programmed on AUTO mode, allowing that the Thermic recovers
the AUTO mode and the set up calendar when finalizing the AUTO-MANUAL mode.
The Thermic's LCD will show both the AUTO and the
MANUAL symbols at the same time to show that the
AUTO-MANUAL is active. For the web and mobile apps
it will show an AUTO+MANUAL symbol.
The AUTO-MANUAL mode ends up automatically in the following target-temperature change
set up in the calendar, getting the AUTO mode back. In order to end up the target-temperature
28