Attach Mounting Plate To Wall - Hessaire H Serie Instrucciones De Instalación

Indoor Unit Installation: 4.2 Attach Mounting Plate To Wall
Attaching The Mounting Plate:
Remove mounting plate—located on back side of indoor unit.
Determine location for mounting plate according to desired indoor unit placement and according to location
recommendations on previous page—Fig. 4.1.
Locate plate so it catches at least one wall stud for sturdy mounting. Note: heavy duty screw anchors are
recommended when attaching plate to sheet rock only, block, brick, etc.
Ensure mounting plate is horizontal and level.
Mark the center of indoor unit on mounting plate for future reference. Note: the center of the mounting bracket
may not be the center of the indoor unit.
Use a minimum of 6 evenly spaced mounting screws to properly support the weight of the indoor unit. (mounting
screws and anchors not included)
Securely tighten all screws and ensure plate is tight to wall.
Notes:
The shape of your mounting plate may differ from the
illustration above but the installation steps remain the same.
Ensure top of mounting plate is level before anchoring to
wall.
Refer to Fig. 4.2 below for mounting plate clearances.
Indoor Unit
Min. Distance
From Wall: 2"
Fig. 4.2
Mounting Plate Clearances:
Min. Distance To Ceiling: 8 in
5
Skill Level
1
Indoor Unit Outline
Indoor Unit
Min. Distance
From Wall: 2"