Foppapedretti RE-KLINO Manual Del Usuario página 20

Installing the car seat
Only install the car seat on a front-facing seat, and equipped with a 3-point belt, compliant
with regulation ECE R16 or equivalent. It is forbidden to use automatic lap belts.
The car seat can only be used with 3-point belts (1).
NOT lap belts (2).
1) 2)
CAR SEAT ADJUSTMENTS
Adjust the position of the seat
The seat is reclinable in various positions.
Press the adjustment lever located under the front of the car seat and, holding it down, pull
or push the seat forwards or backwards (1-A). Release the lever in the required position and
listen for the "click" to ensure that the seat is locked correctly in place.
Adjust the height of the headrest and straps (5-point harness)
Adjust the headrest and straps, pulling the adjustment lever located behind the headrest.
Raise or lower the headrest based on the child's height. A correctly adjusted headrest on the
car seat guarantees the best protection for your child.
Ensure that the "chest belts" are adjusted correctly and slightly higher than the child's
shoulders (1-B).
ATTENTION! Shoulder belts must not be adjusted below the level of the child's shoulders
and/or at the level of his/her ears.
Adjusting the chest belts
1. Press button (A) and pull the straps (chest belts) by grasping them from the bottom,
under the protective chest padding, to loosen them (1-C).
IMPORTANT: Do not pull the straps by the protective chest padding.
2. Pull the chest belt adjustment tension device on the back of the seat and move it up or
down to make the adjustment (1-D).
3. The tension adjusting device must be adjusted based on the height of the child's shoulders
in the position best suited for the child's build (1-E).
20
RE-KLINO