RIDGID 600 Manual Del Usuario página 7

No. 600 Portable Power Drive
Figure 3 – Engaging Die Head in Power Drive
A. Right Hand Thread
Figure 4 – Direction Change Switch/Die Head
orientation.
2. Position the
DIRECTION CHANGE SWITCH
desired right or left hand thread (Figure 4).
CAUTION: Change position of the
only when the motor is switched OFF.
3. Secure pipe in
PORTABLE TRISTAND VISE
, if available.
VISE
W : W
ARNING HEN THREADING
N . 601
O SUPPORT ARM SHOULD BE USED AND
SECURELY LOCKED ON PIPE BECAUSE OF TORQUE
DEVELOPED DURING THREADING
4. Position No. 601
SUPPORT ARM
torque arm is in line with end of pipe (Figure 6).
N : W
OTE HEN THREADING PIPE LESS THAN
,
SUPPORT ARM HOLD ONTO POWER DRIVE HANDLE FIRMLY WITH ONE
HAND TO EXERT PRESSURE AGAINST TORQUE DEVELOPED BY THREADING
5. Place over end of pipe (Figure 7). Make
DIE HEAD
sure is correctly positioned on
POWER DRIVE
. For
PORT ARM RIGHT HAND
rotate clockwise (looking at face of
N : During threading, apply plenty of RIDGID T
OTE
O to dies.
IL
B. Left Hand Thread
for the
DIRECTION CHANGE SWITCH
or
BENCH
"
3 / ,
PIPE OR LARGER THE
4
( 5 & 6).
FIGURES
on pipe so end of
"
3 / , N . 601
IN SIZE WITHOUT O
4
SUP
threads, should
DIE HEAD
).
DIE HEAD
C
HREAD UTTING
Ridge Tool Company • Elyria, Ohio, U.S.A.
Figure 5 – Using No. 601 Support Arm when threading
" pipe and larger
3 /
4
6. Simultaneously actuate ON/OFF
exert pressure against
hand to make sure thread is started.
7. Keep ON/OFF
pipe is even with edge of chaser. Release
ON/OFF
SWITCH
8. Reverse
DIRECTION CHANGE SWITCH
.
HEAD
W : H
ARNING OLD ONTO POWER DRIVE HANDLE FIRMLY TO
RESIST INITIAL TORQUE WHILE BACKING OFF DIE
HEAD
9. Back off
DIE HEAD
ing ON/OFF
10. When dies clear end of pipe, grip handle on top
of
POWER DRIVE
pipe.
.
Figure 6 – Positioning No. 601 Torque Arm in line with
-
end of pipe
with palm of free
DIE HEAD
depressed until end of
SWITCH
to stop
POWER DRIVE
.
from threaded pipe by actuat-
.
SWITCH
and remove
POWER DRIVE
Pipe
Torque Arm
and
SWITCH
.
to back off
DIE
from
5