Mounting - Cameo NANOSCAN 100 Manual De Usuario

SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust or read system settings and information, press the MODE button repeatedly until "SEtt" appears on the display. Confirm with
ENTER. Now you can select and modify one of the following menu items using the UP and DOWN buttons:
-> ENTER ->
UP/DOWN
<- MODE

MOUNTING

Mounting on a truss is performed using the supplied adjustable mounting bracket and a suitable truss clamp (not included). The device must
be secured with an appropriate safety rope to the safety eyelet. NOTE: Overhead installation should only be carried out by trained personnel.
-> ENTER ->
UP/DOWN
<- MODE
Display is
rotated by180°
(overhead mounting)
-> ENTER ->
UP/DOWN
<- MODE
on = display always on
off = display goes off after
approx. 60 seconds of inactivity
-> ENTER ->
UP/DOWN
<- MODE
reversal of the PAN direction
-> ENTER ->
UP/DOWN
<- MODE
reversal of the TILT direction
-> ENTER ->
UP/DOWN
<- MODE
With this menu item, you can define
which operating mode should be enabled
when in the DMX mode,
the DMX signal is interrupted.
-> ENTER
<- MODE
Reset to
factory setting
-> ENTER
<- MODE
Displays the firmware
Version
/
/
/
/
/
Last DMX command Blackout
is held
-> ENTER
-> ENTER
-> ENTER
-> ENTER
/
-> ENTER
Auto Program
7