Stryker Power-PRO IT Manual De Uso página 27

• The LED is solid green when the battery has a full charge or has an adequate battery power charge.
N N o o t t e e - - For best results, use the S S M M R R T T Pak until the cot battery LED indicator changes from solid green to flashing
amber.
• The LED flashes amber when you need to charge or replace the battery
N N o o t t e e - - The cot battery LED indicator does not have to flash amber before you remove and replace the S S M M R R T T Pak,
however, this is considered to be a best practice. You can remove and recharge the S S M M R R T T Pak at any time.
• The LED is a solid amber to indicate a battery error.
N N o o t t e e
• Only use Stryker approved batteries.
• If equipped, the powered cot fastener automatically charges the S S M M R R T T Pak battery. Automatic charging occurs when
you lock the cot into the powered cot fastener (no cable or connectors required). The cot battery LED indicator flashes
green for a moment to signify that it is charging.
• Automatic charging will only occur with S S M M R R T T Pak batteries.
C C h h e e c c k k i i n n g g t t h h e e h h o o u u r r m m e e t t e e r r a a n n d d e e r r r r o o r r d d i i s s p p l l a a y y
The hour meter indicates the amount of time (HHH.H hours) that the hydraulics were in use. The error display provides
error code information for troubleshooting.
Use the hour meter (A) (Figure 12) to determine the frequency of preventive maintenance. Use the error display (A) for
troubleshooting. The error display overrides the hour meter display when an error occurs.
A
6506/6516
F F i i g g u u r r e e 1 1 2 2 – – C C h h e e c c k k i i n n g g t t h h e e h h o o u u r r m m e e t t e e r r ( ( A A ) ) , , e e r r r r o o r r d d i i s s p p l l a a y y ( ( A A ) ) , , a a n n d d b b a a t t t t e e r r y y s s t t a a t t u u s s ( ( B B ) )
O O p p e e r r a a t t i i n n g g g g u u i i d d e e l l i i n n e e s s
W W A A R R N N I I N N G G
• Always operate the cot only when all persons are clear of the mechanisms. Entanglement in powered cot mechanisms
can cause serious injury.
• Always inspect S S M M R R T T Paks for damage before every use.
• Do not allow untrained assistants to assist in the operation of the product.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Do not ride on the base of the cot.
• Do not transport the cot sideways to avoid the risk of tipping. Always transport the cot in a lowered position, head end or
foot end first to minimize the risk of tipping.
6516-209-005 Rev E.0
B
A
6550
23 EN