Stryker Power-PRO IT Manual De Uso página 40

4. Using a 1/2" socket and ratchet, install the four 5/16" hex nuts and washers (A) that you removed in step 1. Tighten all
four nuts.
I I n n s s t t a a l l l l i i n n g g t t h h e e n n o o a a d d a a p p t t o o r r o o p p t t i i o o n n a a i i r r s s l l e e d d t t r r a a n n s s p p o o r r t t i i n n c c u u b b a a t t o o r r w w i i t t h h a a s s l l e e d d r r e e c c e e p p t t a a c c l l e e
The no adaptor option airsled secures incubators without an adaptor to the P P o o w w e e r r - - P P R R O O IT cot.
W W A A R R N N I I N N G G
• Do not install the sled receptacle on any other Stryker cot or on any cot from another manufacturer. These sled
receptacles are for use only on the P P o o w w e e r r - - P P R R O O IT cot.
• Stryker is not responsible for specification or option changes to airsled compatible incubators.
Before you install a sled receptacle (6516-142-000) on the P P o o w w e e r r - - P P R R O O IT cot, read and understand this manual and the
manual that was supplied with the sled receptacle. These instructions explain how to install the airsled with the
manufacturer's supplied sled receptacle (not included).
To install the sled receptacle:
1. Secure the sled receptacle to the litter frame with the supplied fasteners (Figure 42).
2. Insert the airsled (A) into the sled receptacle (B) with the latching system that is included as part of the airsled
EN 36
C
C
B
B
F F i i g g u u r r e e 1 1 9 9 – – A A i i r r b b o o r r n n e e ™ ™ s s t t a a c c k k a a b b l l e e
A
A
A
B
B
D
HEAD END
6516-209-005 Rev E.0