Uline H-3009ST Guía Rápida

H-3009ST, H-3010ST, H-3011ST
H-3640ST, H-5554ST
STANDARD LOCKER
ROOM BENCH
TOOLS NEEDED
Power Drill 1/2" Diameter
Masonry Drill Bit
Bench Top x 1
1. Lay bench top on a smooth, non-marring surface.
Place side with predrilled holes face up. (See Figure 1)
Figure 1
1. Verify that bench is positioned in the desired
location. Mark floor where holes will be drilled. Move
bench in order to drill holes. There should be three
holes drilled for each pedestal.
2. Using a 1/2" diameter masonry drill bit, drill a hole in
all marked locations approximately 2" deep.
3. Clean out debris from inside holes.
4. Insert the anchor bolt and anchor sleeve into the
hole so that the top of the sleeve is flush with floor
and the threaded bolt sticks out of the floor. Slightly
tap down the anchor bolt with a hammer if needed.
(See Figure 3)
PAGE 1 OF 3
1-800-295-5510
uline.com
14mm Wrench
PARTS
Pedestal Base x 2
anchor sleeve, washer, lock washer and nut.)
ASSEMBLY
ANCHORING TO CONCRETE FLOOR
Phillips Head
Screwdriver
Anchor Hardware Set x 6
(Each set includes an anchor bolt,
2. Align three holes on pedestal base with three
predrilled holes in bench top. Secure pedestal to
bench top using three wood screws and screwdriver.
Repeat for second pedestal. (See Figure 2)
Figure 2
5. Align pedestal over the anchor bolts. Slide washer
and lock washer over each anchor bolt. Then
tighten nut until anchor bolt is secure. (See Figure 3)
Nut
Lock Washer
Washer
Anchor Sleeve
Anchor Bolt
Figure 3
Para Español, vea página 2.
Pour le français, consulter la page 3.
Hammer
(Optional)
Wood Screw x 6
Pedestal
Base
0920 IH-3009