Installing Equipment - D-Link DSR-500 Guia De Instalacion

LED Color Status
Indicators
Power / Orange/ Solid
Status Green Orange
Solid Green Completion of power on
Blinking
Orange
Blinking
Green
Light Off
USB Green Solid Green The link is good
Blinking
Green
Light Off
TX/RX Green Light Off
Status
Solid Green Link present.
Blinking
Green
LINK Green/ Light Off
Speed Orange
Solid Green Port is operating at
Solid
Orange
Table 2. Device Status LED Descriptions
DSR-500/1000 Default Interface Settings
Ethernet
Interface Interface Type
LAN(1-4) / Static IP
WLAN
WAN1 DHCP Client
WAN2 DHCP Client
(Configurable (default)
port)
Static IP (When
it's configured
as DMZ)
Table 3. Default Interface Settings
Note: D-Link Unified Services Router only allow
Web GUI access from LAN and WLAN interfaces
by default for security reason.
The WAN2 is a configurable port which support
various and advanced scenario applications.
When WAN2 port is configured as DMZ port, the IP
address will be changed to 172.17.100.254.
Description
Device during power-on
process
Device is crashed and
under recovery mode
The system is defective,
such firmware upgrades
fail.
The device is power-off
There is activity on
this port
No link
No Link.
Port is sending or
receiving data.
Port is operating at
10Mbps.
100Mbps
Port is operating at
1000Mbps
Web-Based
IP Address Management
192.168.10.1/24 Enabled
0.0.0.0/0 Disabled
0.0.0.0/0 Disabled
172.17.100.254/24 Disabled
Installing and Connection
This chapter describes
DSR-500/1000 device in a standard 19-inch
equipment rack and how to connect cables and
power to the device.
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures and injuries:
- Before installation, always check that the power
supply is disconnected.
- Ensure that the room in which you operate the
device has adequate air circulation and that
the room temperature does Not exceed 40
o
(104 F)
- Allow 1 meter (3 feet) of clear space to the front
and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of the
chassis. Ensure that enclosed racks have fans
and louvered sides
- Correct these hazardous conditions before
any installation: moist or wet floors, leaks,
ungrounded or frayed power cables, or missing
safety grounds.

Installing Equipment

You can mount the DSR-500/1000 device into
a standard 19-inch equipment rack. To install an
appliance into a rack:
1. Attach the mounting brackets to each side of
the chassis as shown in figure 3 and secure
them with the screws provided.
Figure 3. Attaching Rack Mount Brackets
D-Link Unified Services Router  3
how to install a
o
C