Noise Risk - EPOX SYNTESI 140 EL Manual De Uso, Mantenimiento Y Recambios

Though the concrete mixer has been manufactured in full compliance
with current standards, residual risks exist that cannot be eliminated,
which involve the use of suitable individual protective devices. Adequate
behaviour to be followed.

NOISE RISK

Please be reminded that checking the use of IPDs is delegated to the
employer.
IMER INTERNATIONAL S.p.A.
SYNTESI 140 EL
Motor does not
start when switch is
turned
When unloading,
the handle will turn
by itself
During mixing the
mixer drum rpm
decreases
* Operation to be carried out by an electrician
14
Fault Cause
Defective power cable
Plug not inserted in
socket correctly
Power cable from
plug to control panel
detached
Loose wire inside
motor circuit board
A wire has become
disconnected inside
the panel
Faulty main switch
The overload safety
device has been
activated
Tipping brake worn
Belts are worn or
slack
GB
Remedy
Check power cables *
Ensure correct
connection
Remake the
connection *
Remake the
connection *
Remake the
connection *
Replace switch
Wait for a few minutes
and then try restarting
the machine
Replace the brake
Tension or replace
the belts