3Com AP9152 Manual Del Usuario página 11

lower than the upper edge of the nuts (do not remove the screws or they may
get lost).
Step2 Adjust the T-rail clips to make the T-rail holder wider than the T-rail, and then
lock the T-rail with the T-rail holder according to the arrow.
(1) T-rail clip
(4) Clip holder
(7) Mounting hook
(9) Before installing the AP to the T-rail, loosen the screw nuts until the screw heads are lower than the
upper edge of the nuts.
Step3 Tighten the M3 × 6 screws on the two clip holders until the screw heads touch
the T-rail, and then fix the screws.
Step4 Check that the T-rail holder is fixed to the T-rail.
Step5 Hook the mounting clip of the wall-mounting bracket to the mounting hook of
the T-rail holder, as shown Figure8.
Step6 Insert the two M4 × 8 screws through the two holes (with a diameter of 5 mm, or
0.20 in.) on the wall-mounting bracket according to the dashed line shown in
Figure8 and fix the screws to the T-rail holder.
Step7 Check that the wall-mounting bracket is fixed to the T-rail.
Step8 Install the AP9152 to the wall-mounting bracket. For details, refer to Installing
the AP on the wall-mounting bracket.
All manuals and user guides at all-guides.com
Figure7 T-rail holder
(2) M4 × 8 screw nut
(5) M4 × 8 screw
(8) T-rail holder
8
(3) M3 × 6 screw nut
(6) M3 × 6 screw