Approved Channels - 3Com AP9152 Manual Del Usuario

On a Network Without Any DHCP Server
The AP uses the default factory configuration that includes the following information.
The default IP address of the AP is 192.168.0.50.
The AP has the Telnet server enabled by default. The default authentication
username and password are admin, and password respectively (case
sensitive). You can remotely manage and maintain the AP through Telnet.
Logging In to the AP (FAT AP)
To log in to the AP that has an IP address configured, follow these steps:
1) Connect the AP to a PC, and ensure that the PC and AP can communicate
with each other properly.
2) Launch a web browser. In the address bar, type your AP's IP address and
press Enter.
3) At the AP login interface, type the username, password, and the verification
code, select the language (English and Chinese are supported at present),
and click Login. The default username and password are case-sensitive:
Username: admin
Password: password
Converting a FAT AP to a FIT AP
If you want to change a fat AP to a fit AP, go to the web page http://www.3com.com to
get the instructions.

5 Approved Channels

The operating channels of the AP vary with countries. Select your country from the
country-selection list.
To conform to FCC , Canada, EU and other country-specific restrictions, the AP may
have shipped with channel restrictions for your country. Please visit the 3Com web site
for the latest software version. Appendix A lists the Software Downloads information.
All manuals and user guides at all-guides.com
10