Terratek TBG150 Manual Del Usuario página 17

3. Monitor the dust bag (if equipped) and empty when approximately half full. Always
empty into an appropriate container. REMEMBER: dust can be hot and cause fire.
4. If the cutting tool has become dull, replace it. Dull cutters will cause increased tear-out
and ragged edges on the cuts.
5. Lubricate all moving parts at regular intervals.
6. To clean the body of the power tool, only use a soft da mp cloth. Do NOT immerse in
water. A mild detergent can be used but NOT petrol or any alcohol based product.
7. Should the power cord become damaged only allow a fully qualified electrician to
replace or repair.
Please read the following carefully
Terratek and/or its distributor has provided the parts list and assembly diagram as a
reference tool only. Neither Terratek nor its distributor makes any representation or
warranty of any kind to the buyer that he or she is qualified to do any repairs or replace
any parts of this product. Terratek and its distributor expressly state that all repairs or
parts replacement should be done by certified or licensed technicians. The buyer
assumes all risk and liability arising out of his or her repairs or parts replacement to the
original product.
LIMITED WARRANTY
This product is covered by a two year warranty from the date of purchase. If the product
is defective in workmanship or material and upon returning the product to its distributor/
dealer in its original packaging, the distributor will repair and/or replace it free of charge.
This warranty DOES NOT COVER normal wear, or any damage as a result of accidents,
misuse, abuse or negligence. Terratek Intl. obligations under this warranty shall be limited
to the repair and/or replacement of the product. Terratek Intl. is not responsible for direct,
indirect, or incidental damages. This warranty is void if the product or any of its components
are modified, altered, or in any way changed, or if the product is used in a manner or with
parts that are not recommended by Terratek Intl. To receive a replacement power tool or
requested warranty service, you must present proof of purchase and return all original
equipment packaged with the original product. The replacement power tool will be covered
by the limited warranty for the balance of the two year period from the date of the original
purchase.
This warranty applies only to the original purchaser and cannot be transferred.
12