NSK Ti-Max X Serie Manual Del Usuario página 2

Intended to use
The handpiece is designed only for clinical dental treatment use by qualified personnel.
CAUTION
· Check for vibration, noise and overheating outside the patient's oral cavity before use. If any abnormalities are found, stop using the handpiece
immediately and contact your authorized dealer.
· Do not attempt to disassemble the handpiece or tamper with the mechanism.
· Do not connect or disconnect the bur and/or handpiece until the motor has completely stopped.
· Do not use bent, damaged or sub-standard burs. This may cause shank bend or brake even within the recommended speed.
· Always keep bur shanks clean. Dirt or debris in a chuck could cause poor bur concentricity or low chuck retention force.
· Do not use the bur other than NSK recommended and do not exceed the drive motor speed recommended the bur manufacturers.
· Always operate with water spray. Failure to do so may result in OVERHEATING.
· Perform periodical maintenance check.
· Do not overpressure to the handpiece and treatment area.
1