Porter Cable PT10 Manual De Instrucciones página 6

Disconnect the tool from the air supply before lubricating or
changing sockets.
• Lubricate tool, see Maintenance section in this manual.
Impact wrench sockets and accessories must be used with this
tool. Do not use hand sockets and accessories.
• Select the required impact
socket. This tool has a 1"
(25.4 mm) square drive, use 1"
(25.4 mm) deep sockets. Use
1" (25.4 mm) extensions only
when needed.
• Connect tool to air hose of
recommended size. NOTE:
The use of a quick connect set
makes connecting easier.
IMPORTANT: The use of air filters
and air line lubricators is rec-
om mend ed.
To use:
• Turn air compressor on and
allow air tank to fill.
• Set the air compressor's regulator to 90 psi. This tool operates at a maximum 90
psi pressure.
• Place tool in forward or reverse position. Push reversing lever to the left side for
forward (right hand rotation) or to the right side for reverse (left hand rotation).
• Depress the trigger to operate tool.
• Release trigger to stop tool.
IMPORTANT: Torque values can vary depending on the size of the air compressor
and the cubic feet of air (SCFM) the air compressor delivers. These values are with the
regulator set at 90 psi.
In the forward position:
In the reverse position:
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing
uses com pressed air to power the tool. Because moisture in compressed air will rust the
air motor, you must lubricate the motor daily. An inline oiler is rec om mend ed.
To lubricate the air motor manually:
1. Disconnect the tool from the air supply holding it so the air inlet faces up.
2. Depress the trigger and place one to two drops of air tool oil in the air inlet
Depressing the trigger helps circulate oil in the motor. NOTE: Use SAE #10 weight
oil if air tool oil is not available.
3. Connect the tool to an air source, cover the exhaust end with a towel and run for a
few seconds.
Any excess oil in the motor is immediately expelled from the
exhaust port. Always direct exhaust port away from people or objects.
Failure to lubricate the tool at the air inlet will void your warranty.
All manuals and user guides at all-guides.com
SqUARE
DRIVE
1st : 600 ft­lb,
2nd : 1,000 ft­lb,
3rd : 1,400 ft­lb,
1,400 ft­lb
MAINTENANCE
6- ENG
TRIGGER
AIR
INLET
REVERSING
LEVER