Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION
UNPACKING
Your Vacuum will come out of the box fully assembled
for your convenience. Please check inside the Dust Drum
for additional components before using this product.
Remove contents of carton. Check each item against
the Carton Contents List.
Contact 1-800-4-RIDGID (1-800-474-3443) from the
US and Canada, 01-800-701-9811 from Mexico or
info@RIDGIDvacs.com if any parts are damaged or
missing.
CARTON CONTENTS LIST (Fig. 1)
Key
Description
A* Detachable Blower ...................................................... 1
B* Lid Assembly ................................................................ 1
C* Dust Drum Assembly .................................................. 1
D* Qwik Lock™ Filter ........................................................ 1
E* Rear Wheel ................................................................... 2
F* Caster ............................................................................ 2
G Extension Wand ........................................................... 2
H Utility Nozzle ................................................................. 1
I
Car Nozzle ..................................................................... 1
J
Blower Wand ................................................................ 1
K
Tug-A-Long Positive Locking Hose with Dual-Flex ... 1
L
Owner's Manual ........................................................... 1
* These parts come preassembled.
D*
E*
F*
SP7124 WD40801 ES.indb 5
SP7124 WD40801 ES.indb 5

ASSEMBLY

WET/DRY VAC ASSEMBLY (Fig. 2)
1. To Attach the Powerhead Assembly to Dust Drum:
2. Lower the Powerhead Assembly onto the Dust
3. To Remove the Powerhead Assembly: Pull out on
Qty
DETACHABLE BLOWER ASSEMBLY (Fig. 3)
Fig. 1
1. To Remove the Detachable Blower from the Lid
A*
H
B*
I
C*
J
K
L
G
5
Place the Powerhead Assembly with the Detachable
Blower Handle aligned above the Vac Inlet Port of
the Dust Drum (C).
Drum (C). Rotate both Latches down until you hear
them snap over the Drum Latch Catches.
the Two Latches and lift Powerhead Assembly from
the Dust Drum. Do not force the Latches to rotate
more than slightly outside Drum Flange.
(A)
Detachable
Blower Handle
Powerhead
Assembly
(B)
(C)
Vac Inlet Port
Latch (2)
Assembly: Press down on the Detachable Blower
Latch located under the Detachable Blower Handle.
Lift the Detachable Blower (A) off the Lid Assembly
(B) of the Vac.
(A)
Detachable Blower
Carry Handle
(B)
Fig. 2
Pull Out
And
Lift Up
Fig. 3
9/10/21 10:19 AM
9/10/21 10:19 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido