DUROFIX RI60176 Manual Información Del Producto página 13

1English1
INSTALLING OR REMOVING BATTERY PACK
C
B
A
Fig.4
The Tool operates with either One or Two battery. Dual batteries installation is
optional for doubling the runtime
TO REMOVE BATTERY PACK: Depress the release button (C) on battery and pull
battery pack (A) out of tool (B). (see Fig. 4)
TO INSTALL BATTERY PACK: Push battery pack(A) onto tool until it locks in place.
(see Fig. 4)
OPERATION
SPEED / TORQUE STAGE SETTING
Press the button to select stage.
1. STAGE 1： 600 rpm / 250ft-lbs(340 Nm)
2. STAGE 2： 700 rpm / 500ft-lbs(680 Nm)
3. STAGE 3： 900 rpm / 800ft-lbs(1080 Nm)
4. STAGE 4： 1,000 rpm / 1250ft-lbs(1690 Nm)
5. STAGE 5： 1,200 rpm MAX./ 2212ft-lbs(3000Nm) (4 LED bright)
NOTE : Ensure Tool is in idle before any setting changes.
NOTE : Auto-Shutoff function is available for Stage 1 to Stage 4 in Forward
Operation. The Tool will stop spinning once torque reaches target level of each Stage.
NOTE : if the red LED lights, error or start up protection triggered. Change battery or
put tool at rest for 30 minutes
VARIABLE SPEED SWITCH
The variable speed switch provides safety feature to the user for fastening.
To turn the tool on, squeeze the trigger switch. To turn the tool off, release the trigger
switch (see Fig. 5A).
Your tool is equipped with a brake. The hammer will stop as soon as the trigger switch
is fully released. The variable speed switch enables you to select the best speed for a
particular application. The farther you squeeze the trigger, the faster the tool will
operate.
English -12