CHIEF iCSPTP2 Instrucciones De Instalación página 11

Installation Instructions
2
2
M x4
7mm
75 x 75mm, 100 x 100mm
A
100 x 200mm, 200 x 200mm
All manuals and user guides at all-guides.com
A E x2
2
G x4
A
8
G x4
3
(G, K) x4
8
6 L x2
E x2
3
INSTALL HEAD ASSEMBLY TO DISPLAY
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight
of all components attached to the iCSPTP2 does not
exceed 40 lbs (18 kg).
1. Proceed as follows:
• If display has a 100 x 200mm or 200 x 200mm
mounting hole pattern, then proceed to Step 2 below
and see figure at bottom left.
• If display has a 75 x75mm or 100 x 100mm mounting
hole pattern, then proceed to Step 3 below.
(See figure at middle left)
2. Install screws (G) through brackets (E) and head
assembly (A) into nuts (M).
(See figure at top left)
3. Carefully place display face down on protective surface.
4. Proceed as follows:
• If mounting holes are recessed into back surface
of display, then proceed to Step 5 below.
• If mounting holes are flush with back surface of
display, then proceed to Step 6 below.
5. Place four spacers (N or P, as applicable) over each
mounting hole on back of display. Select shortest spacer
which will provide adequate fill. All spacers must be same
length.
6. Select screw length:
• For flush mounting holes use screws (G) or (K), as
applicable.
• If using spacers (N), then use screws (H).
• If using spacers (P), then use screws (J).
7. Orient head assembly (A) so that teardrop mounting holes
are aligned with holes in display or holes in spacers (N, P),
as applicable.
iCSPTP2
11