Westward 22XP38 Instrucciones De Operación Y Manual De Piezas página 14

All manuals and user guides at all-guides.com
Westward Operating Instructions and Parts Manual
When a new belt is installed, the torque may be too high, and the Thumb Wheel needs to be
adjusted to decrease the belt tension.
When excessive belt slippage happens, the torque may be too low, and the Thumb Wheel needs
to be adjusted to increase the belt tension.
Perform the following steps to adjust the Thumb Wheel.
NEVER let the machine run with high tension in order to protect the cable from
being damaged.
1. Screw down the Thumb Wheel for 3 complete turns to reduce the tension considerably.
2. Increase the tension a bit at a time while trying to run the machine to see if the tension is
enough.
3. Add a bit more when needed.
Major Maintenance and Part Replacement
Set the Rotation Switch to OFF and unplug the machine before any maintenance.
Wear necessary safety equipment for protection.
Machine Cleaning
When needed, the machine can be cleaned with hot, soapy water and/or disinfectants.
Do not allow water to enter motor or other electrical components. Make sure unit
is completely dry before use.
Cable
To obtain maximum service from your cables, be sure that after each use they are cleaned with
water, air dried, and well coated with proper lubrication oil (such as SAE 10W‐30). This not only
provides running lubrication but greatly extends the life of the cables as well. You can periodically
pour oil directly into the drum. As the drum turns, the cables get complete lubrication. You can
also wipe the lubrication oil on the cable with a cloth.
If a cable loops over itself in the drum, it will not feed properly. Remove and reload the cable by
hand to restore function. If the cable kinks, it is the evidence of abuse and the results from the
use of too much pressure or the use of a wrong size cable for the line.
Cable Feeder (Optional)
Keep Cable Feeder free of excessive soil and grit. It is recommended that the Cable Feeder be
flushed with fresh water using a hose followed by air‐drying the unit and then a lubrication oil of
the moving parts. No disassembly is normally required. If dirt is hard enough to stop the roller's
rotation and flushing it with water does not restore its function, then disassembling the Cable
Feeder is necessary.
22XP38, 22XP39
Drain Cleaning Machine
14