Westward 22XP38 Instrucciones De Operación Y Manual De Piezas página 8

All manuals and user guides at all-guides.com
Westward Operating Instructions and Parts Manual
Cutter Installation and Removal
The machine comes with 3 cutters in the tool box. The cutters can be
exchanged depending on the application.
1. To install a cutter onto the cable, simply slide the male coupling
end on the cable into the notch of the female coupling end on the
cutter from the chamfered side until a click is heard. The
chamfering of the notch bottom is for easy connection.
2. To remove a cutter from the cable, insert the key tips into the hole
on the cutter. Then hold the cable end still with one hand and
slide the cutter off with the other hand along the notch.
Cable Connection and Disconnection
With similar operation, the cable can be extended by adding another
cable. To do this,
1. Remove the cutter from the cable using Step 2 described above.
2. Slide the male coupling end on the existing cable into the notch of
the female coupling end on the extension cable from the
chamfered side until a click is heard (the same as the cutter
installation shown above). Then use the same method to install the
cutter onto the other end of the extension cable (Note: Similar operation is applied when
replacing a worn or damaged cable or cutter with a new one).
Belt Removal/Installation
To remove the drum, motor, or to replace a worn belt, the belt needs
to be removed and installed. To do this,
1. Unscrew the Belt Guard Retaining Screw and take off the Belt
Guard.
2. Push the motor down with body weight to suppress the spring
beneath the motor and shorten the distance from the pulley to the drum.
3. Slide the belt toward the back of the drum until it is loose. Then take it off from the pulley
and take it out around the drum.
4. Reverse the procedure to replace belt.
Drum Removal and Installation
1. Remove optional Cable Feeder if available.
2. Remove the belt guard by following the above procedure.
3. Reach behind the drum and locate the drum‐retaining latch.
Pull the latch to release the drum shaft, then pull the drum
forward off the frame.
4. To install the drum, reverse the above step.
Cable Installation and Removal from Drum
To install cable into the drum, simply push the cable into the drum and make sure the cable winds
in the drum in the counter‐clockwise direction. To remove a cable from the drum, simply pull the
cable out of the drum until the end comes out of the drum.
The cable should lay in the drum in the counter‐clockwise direction.
22XP38, 22XP39
Drain Cleaning Machine
8