ARGENTO OMEGA+ Manual De Uso Y Mantenimiento página 14

3. Loosen the 2 screws on the handlebar tube to allow the handlebar stem to be turned
180°. Align the tube with the front wheel and tighten the screws that were loosened
beforehand.
Remove the plate on the end of the handlebar stem (handlebar attachment) by removing the
2 fastening screws and insert the handlebar in the relevant seat.
Position the handlebar attachment plate, that was removed beforehand, in its original
position and slightly tighten the 2 fastening screws to adjust the correct position of the
handlebars.
Complete the operation by tightening the screws.
1
4. Remove the screw on the front part of the front fork.
Insert the front mudguard so that it passes between the fork and the front wheel, then fasten
it to the fork with the relevant bracket using the screw that was removed beforehand.
Fasten the side supports of the front mudguard to the relevant front fork brackets by
removing and then tightening the screws on the brackets (right and left side).
1
2
2
12
3
3