Uline H-675 Funcionamiento página 2

TAPE
1. Unlock load-and-lock bar by rotating both plastic
knobs toward the front of dispenser.
(See Figure 3)
2. Pull load-and-lock bar until in fully-forward position.
3. Set rolls of tape on base bar so adhesive side faces
down.
4. Pull end of roll about 5" forward over tape cutter.
(See Figure 4)
5. Install roll separators between rolls.
6. Push load-and-lock bar back into original position
and rotate plastic knobs backward to lock.
(See Figure 4)
7. Pull end to cutting bridge.
NOTE: Guard on the tape cover needs to be
removed to cut tape.
PAGE 2 OF 6
OPERATION CONTINUED
Figure 3
Figure 4
Tape
Cutter
1-800-295-5510
uline.com
Load-and-Lock Bar
Tape
Lock
1121 IH-675