Installation; Installation Site - ARVEN KONTRACT Serie Manual De Instrucciones

7 INSTALLATION

7.1 SITE OF INSTALLATION
• Before immersing the electropump in the pit or tank,
ensure that the place is free from sand or solid sediment.
is to be placed.
of the pit so that any deposits that form after installation
• Remove the sediment periodically.
7.2 WORKING CONDITIONS
• The pump cannot operate dry.
• Installation in vertical or horizontal position.
• The housing pit must be frost-free.
7.3 PIPING
• Put the pump into the liquid to be pumped (Inspect for the
max. pumping height, refer to the performance curve)
iron
• Avoid any kind of choking of the output pipe.
least equal to that of the delivery pipe, so as to avoid a fall
in the performance of the pump and the possibility of
clogging.
can move freely (see Paragraph 9.2. "REGULATING THE
FLOAT SWITCH").
the pump so as not so subject the motor to an excessive
number of starts.
forehand to the upper handleo on top of the pump.
NEVER USE THE POWER CABLE TO LIFT THE ELECTRO-
PUMP .
INSTRUCTIONS FOR SAFE USE:
• This appliance is not intended for use by persons
unless they have been given supervision or instruction.
• Children should be supervised to ensure that they do not
22
KONTRACT