Cleaning And Maintenance - EAS ELECTRIC EHC2200 Manual De Instrucciones

Close key fancy light and buzzer
In the power-on mode, press at the same time the "timing key" and
"mode key" for 2 seconds to close key fancy light and buzzer output.
Repeat this action to open them.
Children lock function
No matter in power-on or power-off mode, press "+" and "-" keys
simultaneously for the first time for 2 seconds to open the children lock
function. Repeat this action to close it.
Automatic power-off function
Screen displays "--" if the heater is not under Temperature Control mode.
When the timer function is off, the heater will automatically shut off with no
operation during 12 hours.
Remote-control unit
The use of remote-control unit: Key function is consistent with machine body
control panel.
Intelligent mode
In the Intelligent mode, press "+" and "-" keys to set wanted temperature.
When environment temperature is lower than set temperature (by more
than 2 °C), the product heats in high warm wind mode; when environment
temperature is close to the set temperature (by less than 2 °C or more), the
product heats on low warm wind mode; when environment temperature
is higher than set temperature, the product stops heating.

CLEANING AND MAINTENANCE

1. Light accumulated dust may be removed from the heater with a soft
cloth. Wipe the exterior surfaces of the heater occasionally with a cloth
moistened (not dripping wet) with a solution of mild detergent and water.
Dry the case thoroughly with a soft dry cloth before operating the heater.
2. The fan motor is lubricated by the factory, and will require no further
lubrication.
3. No other user maintenance is required or recommended. If service is
required, send your heater to the nearest authorized service depot.
4. Store heater in a clean and dry place when not in use.
REMEMBER - Portable electric heaters are designed for spot heating, or as
a supplementary heat source. They are not intended to be main sources of
heat during the normal heating season.
7 V.1