EdilKamin NANCY Instalación Uso Y Mantenimiento página 26

DEVICES
extractors, type B heating appliances and other appliances
magnetothermic switch. In the event that the power outlet is
not easily accessible, provide a device to cut off the power
supply (a switch) upstream of the stove (must be provided
damage the stove.
An inadequate earthing system can cause anomalies for which
ve's power.
FIRE PREVENTION SAFETY DISTANCES
walls. In the case of combustible walls (wood, for
example), you must install adequate insulation in a non
combustible material. You are required to adequately insulate
pipe, as they reach high temperatures. All elements made
from combustible and/or heat-sensitive material located
non combustible insulating material, and in any case materials
stove as they are directly exposed to the heat radiating
from the hearth.
AIR INTAKE
stove for combustion.
INSTALLATION
SMOKE OUTLET
must be connected to outside by means of suitable steel pipes
that are resistant to high temperatures(high temperature silicone
diameter it must be improved by entering a pipe that has a
connected to the solid fuel appliances must be cleaned once a
ry). Failure to regularly inspect and clean the stove increases
in the chimney pot. In that case, proceed as follows: Do not
-
tact specialist personnel before reigniting the stove.
TYPICAL EXAMPLES
roof gutter
CHIMNEY POT
- an internal cross-section at the base, which is the same as that
- an outlet cross-section which is no smaller than twice that of
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind, it must be high enough to
catch the wind and avoid downdraft areas in turbulent wind.
- 26
-
-
-
-
-