Craftmade VE56 Instrucciones De Instalación página 3

Preparation
Important: When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.To reduce
the risk of shock, this fan must be installed with an
isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling angle
is not steeper than 35°. Angles greater than
35° will require a 45° angle adapter.
3
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
All manuals and user guides at all-guides.com
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
Step 3
0.75m
84"
(2.1m)
Min.
4a
Step 4a - Standard Mounting Bracket
Prior to securing mounting bracket, screw "J" hook (S7) into ceiling outlet
box as a secondary support means. Secure mounting bracket (1) to the
outlet box (A) by tightening bracket screws & washers (S3) as shown. If
not mounting to an outlet box, use wood screws (S1) and mount securely
to ceiling beam. Be sure at this point to insert canopy screws (S2) in
bracket.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S7)
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
4b
Step 4b - Industrial Mounting Bracket
Prior to securing mounting bracket, screw "J" hook (S7) into ceiling outlet
box as a secondary support means. Secure industrial mounting bracket (2)
to the outlet box (A) by tightening bracket screws & washers (S3) as shown.
If not mounting to an outlet box, use wood screws (S1) and mount securely
to ceiling beam.
30"
"J" Hook (S7)
Min. Ceiling
Bracket Screws
& Washers (S3)
Washers
Wood Screws (S1)
OUTLET BOX
Canopy Screws (S2)
NOTE: Do not mount directly to sheet rock or ceiling tile.
OUTLET BOX
Support Beam
Outlet Box (A)
Mounting Bracket (1)
Wood Screws (S1)
Support Beam
Outlet Box (A)
Industrial
Mounting Bracket (#2)
Washers
Wood Screws (S1)