Main Components; On/Off Button - Grouw 68141 Manual De Instrucciones

Do not till in places where there may be
cables, pipes, etc. buried in the ground.
Only switch the mini-tiller on when it is in the
place you intend to till.
Be particularly careful when working on
slopes to ensure the mini-tiller does not
overturn during work. Always till across the
face of slopes, never up and down. Be careful
when you change direction when working
on slopes. Do not till on steep slopes.
Only use an extension cord with the mini-
tiller that has been approved for outdoor
use and which has a cable cross-section of
at least 1.5 mm 2 . The extension cord must
not exceed 75 metres in length. Unwind
the extension cord fully to prevent it from
overheating.
Always be aware of where the extension
cord is so that you do not run over it with the
mini-tiller. Always keep the extension cord
behind the mini-tiller.
Do not run or walk too fast behind the
mini-tiller. Be careful if you pull the mini-tiller
backwards.
The mini-tiller is intended solely for light soil
tilling in private gardens. It is not intended
for commercial use.
Always carry the mini-tiller when moving it
from one place to another.
36

Main components

1. Support grip
2. On/off button
3. Safety button
4. Handle
5. Hook for cord
6. Cord and plug
7. Wing screw for support grip
8. Wing screw for shaft
9. Lower shaft
10. Carrying handle
11. Ventilation slots
12. Shield
13. Blades
1 1
9 9
bl bl
2 3 2 3 4 4
5 5
6 6
7 7
8 8
bm bm
bn bn
bo bo