During Use; After Use; Before Use - Skil 6950 Manual Original

Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc., in
accordance with these instructions, taking into
account the working conditions and the work to be
performed.
5) SERVICE
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
SAFETY INSTRUCTIONS FOR IMPACT DRILLS
GENERAL
16 years
Do not work materials containing asbestos (asbestos
making any adjustment or changing any accessory
ACCESSORIES
when original accessories are used

BEFORE USE

you start working
Secure the workpiece (a workpiece clamped with
Use suitable detectors to find hidden utility lines or
call the local utility company for assistance (contact
penetrating a water pipe will cause property damage or
reactions and/or respiratory diseases to the operator or
wear a dust mask and work with a dust
extraction device when connectable
wear a dust mask and
work with a dust extraction device when
connectable
materials you want to work with

DURING USE

Wear ear protectors when impact drilling (exposure
Use auxiliary handle(s), if supplied with the tool
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord
tool
handle G 2 and take a secure stance

AFTER USE

standstill
USE
4
! change direction of rotation only when tool is at a
complete standstill
8
- turn switch D to "changing bits" until it snaplocks (only
activate when tool is switched off and plug is
disconnected
- insert the bit as deep as possible in the chuck
mounted correctly
! do not use damaged bits
! never start drilling with switch D set for
"changing bits", as this could damage the tool
- turn switch D to the desired operating mode until it
snap-locks
! select operating mode only when tool is switched
off and plug is disconnected
9
always use auxiliary
5
6
7
9